It's the starboard side. The only destruction I had to do was pry a couple of small interior frame pieces away because the screw heads were inaccessible because of the tank. Basically pried about 6 screws away but didn't break the boards. When I reinstall, I'll drill new holes from the outside and use wooden bungs on anything that shows. Only other thing was I sawed off the outlet fitting elbow so I could unscrew it. The alternative would have been removing the next piece forward on the inboard face of the settee so there would have been room to move the tank enough to unscrew the elbow. When I reinstall, I may use a straight fitting if needed. The other issue I ran into was stripping old screw heads on hard to reach areas. I was able to get out just enough though to finagle things around for removal. If stripped heads weren't an issue, would have made things easier. I have an extractor for my drill, but the places this would happen, were impossible to get to with it as well. There is a post somewhere on here I've seen about accessing the fridge.
_________________ Zach Duncan SV Holiday Hull# 280
|